Jonkman Microblog
  • Login
Show Navigation

  • Public

    • Public
    • Network
    • Groups
    • Popular
    • People

Conversation

Notices

  1. Alex (avolkov@mastodon.xyz)'s status on Friday, 24-Aug-2018 21:07:44 EDT Alex Alex

    #3dprinting #prusa #prusaclone

    Any suggestions of what might cause bed probe to detect bend like this? I tried two different heated bed and this thing shows up in the same spot. I suspect something is misaligned on Y-axis.

    In conversation Friday, 24-Aug-2018 21:07:44 EDT from mastodon.xyz permalink
    1. Alex (avolkov@mastodon.xyz)'s status on Friday, 24-Aug-2018 22:51:45 EDT Alex Alex
      in reply to

      Turns out Z axis was out of alignment.

      In conversation Friday, 24-Aug-2018 22:51:45 EDT from mastodon.xyz permalink
  • Help
  • About
  • FAQ
  • TOS
  • Privacy
  • Source
  • Version
  • Contact

Jonkman Microblog is a social network, courtesy of SOBAC Microcomputer Services. It runs on GNU social, version 1.2.0-beta5, available under the GNU Affero General Public License.

Creative Commons Attribution 3.0 All Jonkman Microblog content and data are available under the Creative Commons Attribution 3.0 license.

Switch to desktop site layout.